简介什么是油脂浸出，油脂浸出设备的工艺特性

　

    浸出设备；简介什么是油脂浸出，油脂浸出设备的工艺特性
　油脂浸出工序是来自预处理车间或预榨车间的油料生胚或预榨饼，由刮板输送机送入存料斗，存料斗下面是一个锥形关闭阀式的下料器。
Oil extraction process is embryo or pre pressing cake from oil pretreatment plant or pre pressing workshop, by scraper conveyor into deposit hopper, hopper below is a tapered off valve type feeder.
关闭阀下料器中阀芯的转速与存料斗中的料位协作，自动控制存料箱中的料封高度，有效地避免了浸出器内的溶剂气体经过进料设备向预处理车间倒逸。
Closed valve feeder spool speed and storage hopper in the material level collaboration, automatic control storage bins in the material sealing height, effectively avoid leaching solvent gas after feeding equipment to the pre processing shop down the escape.
入浸油料经过关闭阀均匀地进入浸出器内转子的浸出格中，跟着转子的缓慢翻滚，浸出格中的油料遭到不一样浓度混合油的喷淋浸泡，最后用新鲜溶剂喷淋浸泡，在浸出格中油料与混合油和溶剂构成一个逆流浸出进程。
In the leaching case of the rotor, the oil is mixed with the same concentration of the oil. The oil is mixed with mixed oil and solvent in the leaching process.
混合油的循环是由混合油循环泵完结的。浸出后的油料在浸出格中经滴干后排入出粕斗。
The cycle of the mixture is the end of the mixed oil cycle. After leaching oil leaching in the lattice into a bucket to drip after meal.
这儿的出粕设备选用装有两个拨料翅的圆筒出粕器，使得出粕量比照均匀，既极好地处理了出粕斗搭桥疑问，又能缓冲浸出格间歇出粕时湿粕对刮板的冲击。
Here the selection of the meal equipment with two dial material wings of a cylinder out of the meal, so that the amount of the meal is uniform, not only a good deal with the question, but also to buffer the impact of the leaching of oil from the oil cake.
湿粕经刮板输送机送往蒸脱机。
The wet meal is sent to steam by the scraper conveyor.
由混合油泵抽出的浓混合油经旋液分别器分别粕末后被送往混合油处理工序。
Thick mixed oil extracted by mixed pump with rotary liquid respectively respectively were sent to the last meal mixed oil processing procedures.
一般，平转浸出器中料层高度为2～3m，浸出时刻为90～120分钟，浸出温度50～55℃，浸出后湿粕含溶剂30%以下，混合油浓度为20～25%。
In general, the height of the material layer height is 2 ~ 3M, the leaching time is 90 to 120 minutes, the leaching temperature is 50 ~ 55, the content of the wet meal is 30%, the concentration is 25% ~ 20.